illegal mode for this track end of user area encountered on this track RPL status change operator request or state change input unable to recover table-of-contents media load or eject failed cartridge fault erase failure write append error overlapped commands attempted logical unit failed self-configuration data phase error command phase error invalid message error initiator detected error message received SCSI parity error unsuccessful soft reset select or reselect failure internal target failure message error power-on or self-test failure data path failure RAM failure target operating conditions have changed logical unit has not self-configured yet invalid bits in identify message sequential positioning error medium not present saving parameters not supported rounded parameter tape length error no defect spare location available medium format corrupted incompatible medium installed commands cleared by another initiator overwrite error on update in place command sequence error copy cannot execute since host cannot disconnect parameters changed power on, reset, or bus device reset occurred not ready to ready transition, medium may have changed write protected invalid field in parameter list logical unit not supported invalid field in CDB illegal function logical block address out of range invalid command operation code recovered ID with ECC correction miscompare during verify defect list not found parameter list length error defect list error recovered data with error correction applied recovered data with no error correction applied data synchronization mark error random positioning error recorded entity not found address mark not found for data field address mark not found for id field unrecovered read error id CRC or ECC error write error error log overflow track following error logical unit communication failure multiple peripheral devices selected no reference position found logical unit does not respond to selection logical unit not ready peripheral device write fault no seek complete no index/sector signal